CompuSTAR CM6300 Przewodnik Instalacji Pobierz pdf (Strona 30)

Whenever I try to arm the vehicle, it chirps the siren 3 times and will not arm.

A: Check the hood and trunk trigger inputs.

Do the door locks flip flop in polarity?

A: No. You can use the CompuPack (relay pack) for high current positive (+) locks, or the DM600 harness

used for low current 600mA positive (+) locks.

What are Firmware Version Diagnostics?

A: When you turn the Ignition on and hold buttons 1 and 4 or Lock and Key/Start for 2.5 seconds then the

parking lights will flash 1 time on the CM6 series showing V.1 and so forth. Current version 3.11 should

show 3 flashes when triggered.

What is this cartridge slot on the rear of the CM6300?

A: This is the slot for the Blade cartridge system. This slot is for the Idatalink Blade remote start bypass

modules. For more information on the compatibility and install information please visit www.idatalink.com/

fitguide. Using this system eliminates many connections between your standard control module and bypass

module. IMPORTANT: If you are not using the Blade then you will not have or use the 20 pin connector

next to the back up battery port.

I’m using the RPS Touch but my LED’s and Secure Valet LED does not flash.

A: The CM6000 and CM6300 LED and Secure Valet LEDs will not work when using an RPS Touch. This is a

hardware limitation. The RPS 2 will work with LEDs and Secure Valet.

CM6300 Install Guide

Alarm System

www.firstechonline.com | www.compustar.com

Page 30

1 2 ... 25 26 27 28 29 30 31

Brak uwag

CompuSTAR CM6300 Przewodnik Instalacji Strona 30